Internal Vents Buy on Amazon

Door vent 17.7 × 3.6 in, two-sided

Louvered ABS grille for interior doors. Fits a 17 × 3⅛ in (432 × 80 mm) cut-out in doors 1 to 1¾ in thick.

Color: White

White two-sided louvered door vent, 17.7 × 3.6 in, front view

Measurements

The cut-out is what matters. The frame overlaps it by a few millimetres on every side.

Door vent dimensions Outer frame 17.7 by 3.6 inches (450 by 92 mm). Cut-out in the door 17 by 3 1/8 inches (432 by 80 mm). Fits doors 1 to 1 3/4 inches (26 to 44 mm) thick. Frame 17.7 in 450 mm Cut-out 17 in 432 mm 3.6 in92 mm 3⅛ in80 mm cut-out Door 1–1¾ in 26–44 mm Section through door

Specifications

Outer frame17.7 × 3.6 in (450 × 92 mm)
Cut-out in the door17 × 3⅛ in (432 × 80 mm)
Door thickness1 to 1¾ in (26–44 mm)
ConstructionTwo halves that slide into each other through the door, louvers aligned on both sides
MaterialABS plastic, heat resistant to 140 °F (60 °C)
Weight236 g (8.3 oz) per set
ColorsWhite, Beige, Gray, Brown, Black
In the box2 vent halves, full-size cutting template, screws in 25, 35 and 45 mm
Made inEU

What it does

A closed door with no gap underneath cuts a room off from the rest of the house. Air can't get in to replace what an exhaust fan pulls out, and air blown in by a heating or cooling register has no easy way back.

The vent gives that air a path through the door while it stays shut.

Two halves, one opening

Each half has a sleeve. You push one in from each side and they slide into each other, lining the opening and covering the raw edges of the cut. That's what lets one size work on doors from 1 to 1¾ in thick.

Why plastic

ABS doesn't rust in damp bathrooms and laundry rooms, weighs 236 g a set, and is easy to fit. It's heat resistant to 140 °F (60 °C).

In five colors

White door vent fitted near the bottom of a matching interior door
White
Beige door vent fitted near the bottom of a matching interior door
Beige
Gray door vent fitted near the bottom of a matching interior door
Gray
Brown door vent fitted near the bottom of a matching interior door
Brown
Black door vent fitted near the bottom of a matching interior door
Black

How to install it

  1. Mark the cut-out

    Take the door off its hinges and lay it flat. Tape the template where the vent will go, usually low on the door, and trace it.

  2. Drill the corners

    Drill a hole inside each corner of the outline with a 3/8 in bit. Painter's tape over the lines helps stop the face from chipping.

  3. Cut the opening

    Join the holes with a jigsaw and a fine-tooth blade. Keep to the line: the opening should be 17 × 3⅛ in.

  4. Fit both halves

    Push one half in from each side. The sleeves slide into each other so the louvers line up on both faces.

  5. Screw together

    Pick the screw length that matches your door thickness (25, 35 or 45 mm) and tighten until the frames sit flat.

Step-by-step guide with tools and tips