Internal Vents Buy on Amazon

How to install a door vent

Cutting a vent into an interior door takes about an hour with a drill and a jigsaw. Here's how to get a clean opening the first time.

What you need

  • The Internal Vents door vent, with its cutting template and screws
  • Tape measure and pencil
  • Painter's tape
  • Drill with a 3/8 in (10 mm) bit
  • Jigsaw with a fine-tooth blade for wood
  • Screwdriver
  • Sandpaper or a file to clean up the edges

Before you cut

Check that the door is between 1 and 1¾ in (26–44 mm) thick. Most interior doors are 1⅜ in.

Decide where the vent goes. Low on the door is usual: it's out of sight and, in a bathroom, it lets in replacement air near the floor. Keep the vent clear of the hinges, the lock and any panel moulding.

If the door is hollow-core, knock along it. It sounds solid over the wooden rails at the edges and hollow in between. Place the vent in a hollow area above the bottom rail.

Step by step

1. Take the door down and mark the cut-out

Lift the door off its hinges and lay it flat on two trestles or a table. Tape the template to the side you want to look best, centred across the width, and trace around it. The opening should be 17 × 3⅛ in (432 × 80 mm).

2. Drill the corners

Put painter's tape along the outline to stop the door skin from splintering. Drill one 3/8 in hole inside each corner, touching the lines.

3. Cut along the lines

Start the jigsaw in one of the holes and cut from corner to corner. Go slowly and stay on the line: a crooked cut is harder to cover. Peel off the tape and sand any rough edges.

4. Fit the two halves

Push one half into the opening from each side. The sleeves slide into each other, so the louvers line up on both faces of the door.

5. Screw them together

Choose the screws that suit your door: the shorter ones for thin doors, the 45 mm ones for 1¾ in doors. The template has a table to help. Tighten until both frames sit flat, without over-tightening the plastic.

Rehang the door and you're done.

If the hole is slightly too big, the frame still overlaps it by about 6 mm top and bottom and 9 mm at each end. If it's too small, trim it with the jigsaw until both halves slide in without forcing.

The five steps at a glance

  1. Mark the cut-out

    Take the door off its hinges and lay it flat. Tape the template where the vent will go, usually low on the door, and trace it.

  2. Drill the corners

    Drill a hole inside each corner of the outline with a 3/8 in bit. Painter's tape over the lines helps stop the face from chipping.

  3. Cut the opening

    Join the holes with a jigsaw and a fine-tooth blade. Keep to the line: the opening should be 17 × 3⅛ in.

  4. Fit both halves

    Push one half in from each side. The sleeves slide into each other so the louvers line up on both faces.

  5. Screw together

    Pick the screw length that matches your door thickness (25, 35 or 45 mm) and tighten until the frames sit flat.