Door vents are sold under three different numbers, and sellers don't always say which one they mean. The same grille might be listed as 18 × 4, 17.7 × 3.6 or 16 ⅞ × 3. Here's what each refers to.
The three measurements
Frame size
The outside of the visible frame. It's always bigger than the hole, because it has to cover the cut edges. Ours is 17.7 × 3.6 in (450 × 92 mm), which some listings round up to 18 × 4.
Cut-out size
The opening you cut in the door. This is the number that decides whether a vent fits. Ours needs 17 × 3⅛ in (432 × 80 mm).
Door thickness
Two-sided vents have sleeves that slide into each other through the door, so they only work within a range of thicknesses. Ours takes doors from 1 to 1¾ in (26–44 mm). Standard interior doors are usually 1⅜ in.
Measuring for a replacement
- Unscrew and remove both halves of the old vent.
- Measure the hole in the door, width and height, at its smallest point.
- Measure the door's thickness at the edge.
Compare the hole with the cut-out size of the new vent. Our frame overlaps the 17 × 3⅛ in cut-out by about 9 mm at each end and 6 mm top and bottom, so a hole slightly larger than the cut-out is still covered. If your hole is smaller, you can enlarge it with a jigsaw using the template in the box.
Quick reference
| Frame | 17.7 × 3.6 in (450 × 92 mm) |
|---|---|
| Cut-out | 17 × 3⅛ in (432 × 80 mm) |
| Door thickness | 1–1¾ in (26–44 mm) |
| Screws included | 25, 35 and 45 mm |